Setup Menus in Admin Panel

  • No products in the cart.


You must be logged in to take this course  →   LOGIN | REGISTER NOW

Restricted Electrical Course


    The aim of this program is to equip participants with the skills and knowledge to safely disconnect and reconnect fixed wiring electrical equipment. Specifically, the course encompasses working safely, identifying supply arrangements, following isolation procedures, selecting and using testing and measuring devices, terminating and connecting cables and conductors, and safely testing and reporting. It excludes disconnecting or reconnecting circuits at a switchboard or to general electrical accessories or installation of or alteration to any part of the fixed electrical wiring system.


    • To be eligible for this course you need to hold an Electrical Work Training Permit from the Electrical Safety Office prior to course commencement. (Form 21 – see the ESO website The Electrical Work Training Permit ensures that the student holds the prior knowledge required to apply for a Restricted Electrical Work Licence.
    • The participant must hold a Certificate III qualification or higher from a designated trade
    • Be registered as an apprentice in an electrical trade
    • Or provide at least 5 years experience in an electrical trade

    The course includes of the following units of competency:

    UEENEEE101A Apply Occupational Health & Safety Regulations, codes and practices in the workplace

    UEENEEP012A Disconnect-reconnect composite appliances connected to low voltage installation wiring

    UEENEEP013A Disconnect-reconnect control devices connected to low voltage installation wiring

    UEENEEP017A Locate and rectify faults in low voltage composite appliances using set procedures

    UEENEEP024A Attach cords and plugs to electrical equipment for connection to a single phase 230 volt supply

    UEENEEP025A Attach cords, cables and plugs to electrical equipment for connection to 1000 Va.c or 1500 Vd.c supply

    Note: Guardrite does not deliver training of the contents of this course, but delivers assessment only, although training material is available to participants.

    Upon successful completion of all components of this course, learners will be in a position to apply for a restricted electrical licence. To apply for a restricted electrical licence you need to demonstrate a regular need to carry out electrical work as part of your primary work function.

    Refer to Section 44 of the Electrical Safety Regulation 2013 (the ES Regulation) and the Electrical Safety Office Licensing Eligibility Policy for eligibility requirements for a restricted electrical licence.

    Fees: $800 (all six units) or $200 per separate unit.

    Booking inquiries: 07 5597 5527

    © Guardrite. All rights reserved.